RO Booster Pump 50GPD Filter System

50BOOST RO Booster Pump for 50 gpd Reverse Osmosis Filter System, complete with power supply & 1/4" connections 
Free Shipping available in United Kingdom

In Stock

£45.95 inc-VAT

 


Booster Pump & power supply, will suit a 50gpd RO filter system. This is as fitted to our Reliable Vyair Reverse Osmosis Water Filters. These are optimised to work with most standard  unpumped RO Water Filters. This pump is also suitable for use with 75gpd reverse osmosis membranes.

Supplied with 1/4" push fit pipe fittings
Package Contents
  • Pump
  • Power Supply
  • Fitted Power Plug
  • Fitted Electrical Connections to join pump & power supply together
  • 1/4" push fit  x 3/8" NPT threaded pump fittings
  • Roll of PTFE thread sealing tape.
If you need help or advice, please call us on 01507 524576 or email  us at sales@vyair.com

As you may be aware that RO Water Filter output is dependant upon a good Water Pressure & Water Temperature. Here in the UK the Tap water temperature is quite stable, but the mains water pressure can vary from a low 20 to a high 80psi, (1.5-5.5bar). Most RO systems do require 50psi to operate well. If you have a RO system and the output is extremely low you may need a booster pump.

Booster pumps will dramatically improve the amount of water produced from you  RO Water Filter. As a rule of thumb if you can provide the right pressure & volume of water for your system you should be able to achieve approximately, 50/60% of the rated membrane output. 

Membranes are tested at 23ºC and for each ºC below this temperature you lose around 4% output, this is a guide. So the sellers on the internet that state one of their pumps will ensure you get the stated output from the membrane do not understand the technicalities of the product. We would rather provide you with the information that we know to be accurate.

It is important to match the capacity of your pump to the size of your membrane. It would be pointless pairing this pump up with a 200 gallon membrane and expecting an amazing result as the output is too low specifically designed for a 50 or 75gpd membrane.

Technical Information

  • Pump 24 volt .65amp
  • Flow .6 litres per minute
  • Pump ports 3/8" Female NPT threads
  • Working pressure 80psi
  • Power Supply input 220/240v 50htz / Output 1.2amp 24volts ( works with normal UK electricity supply).
  • This pump is not designed for 24/7 continuous operation, and should be rested for 10-15mins every 5-6hrs
Inc.VATShow Ex.VAT
 
Your Shopping Basket
No Items In Basket
Total : £0.00
Need some help?
Call 01507 524576
 

 
Easy Product Finder
Page displayed in:0.1719seconds.