Amfor 75 Gallon ULP Membrane

TW30-1812-75
Ultra Low Pressure, Reverse Osmosis 75 Gallon a day membrane for most types of reverse osmosis water filters.

Free Shipping available in United Kingdom

In Stock

£25.94 inc-VAT

 


AMFOR TW30-1812-75 is a 12" x 12" Domestic Reverse Osmosis Membrane that will provide 75US Gallons per day, 12 Litres per hour (0.28cubic meters) per day at optimum output. It is an Ultra Low Pressure Domestic Reverse Osmosis Membrane that can be used in most types of RO filters.

The Amfor membrane has a 50Psi output, which is the same pressure as most homes. This means you can expect to achieve a much higher RO water output than most other membranes that need a pressure of 60-70Psi, making them less suitable to the average home.

Other Reverse Osmosis membranes are difficult to remove from their housing, with pliers or grips need to be struggled with to break the seal. The Amfor membrane has a hexagonal thread on the end, so you simply insert an Allen key, turn, and remove the membrane. On top of this, the American Membrane technology means a 20% increased water output at lower water pressures.


AMFOR® reverse osmosis membrane elements for home drinking water are the most reliable. Advanced membrane technology and automated fabrication allow these elements to keep consistent performance and suitable for long distance transportation. AMFOR home drinking water elements are rated at 50psi and will purify about 20% more water than competitive elements rated at 60psi.

Operating conditions:
- Elements contain preservative solution, therefore the permeate from the first hour of operation should be discarded, to flush the protective solution in the elements.

- Keep elements moist at all times after initial wetting

- CSM elements should be immersed in a protective solution during storage, shipping or system shutdowns to prevent biological growth and frost damage.

If the operating conditions are not followed appropriately , we can not honor the warranty of the element as you will be unnecessarily reducing the life of the filter.

Features

  • 75US Gallons per day, 12 Litres per hour (0.28cubic meters) per day at optimum output
  • 12" x 12" RO Membrane
  • The standard storage solution contains one weight percent sodium bisulfite or sodium metabisulfite (food grade). For short term storage of one week, one weight percent sodium metabisulfite solution is adequate for inhibiting biological growth.

Technical Information

  • Membrane Type .....Polyamide Thin-Film Composite
  • Maximum Operating Pressure ..... 300psi (21bar)
  • Maximum Feed Rate..... 2.0gpm (7.6 lpm)
  • Minimum Concentrate Flow Rate ..... 4 × permeate flow
  • pH Range Continuous Operation (see a).....2-11
  • pH Range, Short-Term Cleaning(30min) (see b)..... 1-12
  • Maximum Operating Temperature.....113degF (45degC)
  • Maximum Feed water Turbidity .....1 NTU
  • Maximum Feed Silt Density Index.....5
  • Free Chlorine Tolerance (see c).....<0.1ppm
  • a Maximum temperature for continuous operation above pH 10 is 95degF (35degC).
  • b Refer to Cleaning Guidelines of ANDE-AMF.
  • c Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, AMFOR recommends removing residual free chlorine by pretreatment prior to membrane exposure. Please refer to technical bulletin ANDE-AMF for more information.
Inc.VATShow Ex.VAT
 
Your Shopping Basket
No Items In Basket
Total : £0.00
Need some help?
Call 01507 524576
 

 
Easy Product Finder
Page displayed in:0.2207seconds.